My Nabaztag/tag’s nose flashes orange/green and I can’t connect him

NOTE : this announcement only concerns Nabaztag/tags (those with the bellybuttons) whose nose LEDs are blinking orange and green. If this is not happening to your Rabbit, this procedure may be ignored.

Before anything else, download the following document on your computer (the one that you use to configure your rabbit): www.nabaztag.com/firmware/firmware.0.0.0.10.sim.txt (right click - Save file under)

Follow these instructions:

  Unplug your rabbit
  Push and hold the button on the top of his head
  While keeping the button pressed, plug him back in
  Once all 4 of his lights turn blue, release the button

Look in the list of available wireless networks on your computer that is furnished with a Wi-Fi card (you may have to refresh the list of networks) and connect to the wireless network “nabaztagXX” (the XX is the last two digits of your Rabbit’s serial number found on his bottom).

Once connected to the Nabaztag network, open your internet browser and type in the address http://192.168.0.1

PLEASE DO NOT UNPLUG YOUR RABBIT DURING THE REST OF THIS PROCEDURE.

On your Rabbit’s configuration page, all the way at the bottom, verify that the version of your firmware ends with a 9 (if this isn’t the case, this procedure may be ignored).

Go back to the top of the page and click on “Click here for firmware upgrade” (in the top right-hand corner).

On the page that appears, Click on Browse and find the file that you had just downloaded earlier.

Click on Upload.

The Rabbit will flash red lights and then white, then he will restart.

You should now pass the point where your Rabbit has an orange/green nose and see that his ears turn and he lights up purple at his base. This means he is correctly connected to the internet.